We replaced transmission in this car. Swapped the valve bodies to the new transmission. The at oil temp light us flashing? We are trying to figure out why it will not start with out clearing the codes. Does the tcm need to be reprogrammed please help.
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
2014 subaru outback limited 3.6l after transmission replacement
- Thread starter jwsubaru
- Start date
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.
Similar Threads
Forum statistics
Latest Threads
-
Dealer lost the history report where can I find it myself
- Started by Chris Dalton
-
Speed that oil drai from the filter back thru the pump to sump?
- Started by scubazteve
-
2018 Outback with excessive battery drain
- Started by MSDS
-
Block off line from manifold to purge valve
- Started by angeloj198
-
Brake Light Adjustment
- Started by gbsk
-
Thumping sound when wheel is turned hard in either direction.
- Started by Frank54
-
Rear hatch Light Switch
- Started by junkyardhz
-
Headlights
- Started by Flip
-
Blank (switch) beside parking lever/switch
- Started by semag93
-
2019 Forester have a timing belt or a timing chain
- Started by Dianne