I just replaced the passenger side cv axle, knuckle, wheel bearing, and abs sensor. It was making a clunking noise before i changed everything. Now there is no noise but the slip indicator light comes on when going forward and backwards. It feels like the wheel isn't turning properly but when the cv axle was installed it was properly seeded. Any thoughts?
You are using an out of date browser. It may not display this or other websites correctly.
You should upgrade or use an alternative browser.
You should upgrade or use an alternative browser.
2015 subaru legacy slip indicator light coming on
- Thread starter am99206
- Start date
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments. After that, you can post your question and our members will help you out.
Similar Threads
Forum statistics
Latest Threads
-
New Subaru owner here
- Started by QWSADSCXC
-
WRX rear brake line leaking
- Started by RonC6
-
2015 Forester purchase advice - CVT concern
- Started by Mike05
-
Passenger door won't latch
- Started by TulsaBob
-
Subaru impreza 2012
- Started by gillard
-
Wheel Swap
- Started by scoobysnick
-
Hella Horn Wiring for cheap?
- Started by 05RS.treehitter
-
Vehicle dynamics control stays off when toggled on - why?
- Started by sipora
-
2015 forester-High setting on blower
- Started by mcnala
-
Subaru Crosstrek 2020 blown fuse15) D-OP+B
- Started by DJFii