2013 Legacy lower control arm replace

[Subaru-Sam]

Hi, I am trying to replace the drivers side lower control arm on my wife's 2013 Legacy and I am running into problems removing the inner rear bolt that goes through the large round bushing. The nut on top came loose without any problems but the bolt will not budge. So is this bolt pressed in or is stuck because of rust. Thanks, Bob

 

[remy6908]

You may need to put a small jack under the control arm to lift the suspension slightly to allow the pressure on the bolt to be relieved. If that doesnt work the bolt may be seized to the bushing and in that case, penetrating oil and heat will be the easiest to get it off. I would suggest replacing that bolt with a new one if you have to go that route.